Encasing the circuit board in epoxy. It makes it very difficult to access components without destroying it. It’s also great for water proofing and increasing the mechanical robustness.
There is potting compound with high thermal conductivity for things that produce a lot of heat. A YubiKey hardly uses any power, so heat should not be an issue.
The main downsides of potting are that it makes repair practically impossible and it can add a lot of weight if there is a large volume to be filled.
Potting Grrrr. My fancy track lighting has been potted. It sucks because absolutely no place (even China) sells the 48v LED driver with the odd body shape to bypass the internal mounting screws, and the potting means I can’t access the board to desolder a resostor or something
Potted?
Encasing the circuit board in epoxy. It makes it very difficult to access components without destroying it. It’s also great for water proofing and increasing the mechanical robustness.
No negatives listed on the Wiki page. Are there any? Does potting increase the likely hood of overheating?
There is potting compound with high thermal conductivity for things that produce a lot of heat. A YubiKey hardly uses any power, so heat should not be an issue.
The main downsides of potting are that it makes repair practically impossible and it can add a lot of weight if there is a large volume to be filled.
that makes sense. Thank you.
Thanks! That makes a lot of sense.
Potting Grrrr. My fancy track lighting has been potted. It sucks because absolutely no place (even China) sells the 48v LED driver with the odd body shape to bypass the internal mounting screws, and the potting means I can’t access the board to desolder a resostor or something