Well you are in luck. No video but images of analysis. Hedgehog plot of normal vectors, they converge to flat at stem base. Hard to see since the stem/dimple share space.

Confirmation of immediate angle at stem base

Slope plot. Green being 0 degrees from up vector.

Dimple hole showing its not a cylindrical stem

Stem slope, green being immediate 0 vector

Seems the same if Trump gets his wau

Based on USA slipping in to Nazi dictatorship, what could be a “bad” invader?

This is awesome, but before you buy a printer and put this much effort in, they sell sections of articulated spout you can bend to the shape you want

Meh, let them weaken their country so a good invader can take over and correct the bullshit

Such a good tune and spoof

Usually a Thai curry from scratch (even the curry paste), or a four Daal Fry. Since COVID and WFH, I have bought a wide range of spices and have been cooking everything from scratch. Eating at a restaurant is almost always disappointing now.

I’m on a trip so won’t have access to my CAD analysis tools, so no video I’m afraid.

No you weren’t. That will be £5

I traveled in March for a prearranged work trip. The airport US customs asked way less this time and didn’t even question where or why. Much less hassle than before. The airport was empty for departing to USA due to travellers cancelling a lot of US trips, I assume at least at the airport I was at the border agents were told to make it easy because they needed tourism. But that is a guess.

Doesn’t matter, the point where stem and dimple are deepest and encapsulated would have same vector direction initially. Topology doesn’t need to be cylindrical to have vectors

Exactly. Its the best part of Linux. I like what Zorin did, they customized backend of GNOME to give you 4 choices of DE style.

At the deepest part where it surrounds stem tightly there will be an instant tangent which then immediately becomes non tangent. A G0 and G1 condition and not G2

Sometimes its a slight hang of a dialog box, like delay. Sometimes its a dialog getting stuck on top of other dialogs and it becomes unresponsive. Like it is above all other apps on screen.

And hard to describe minor stuff that just feels a bit off. Where as when I go back to GNOME it is smooth like a fully finished environment.

Maybe most people don’t notice stuff like that, but I’m the type of guy that friends call when they want to buy a used car. 500ft and I’m like nope, bad bearing on right side, transmission shudder at start off, worn bushing in steering…and others are like it drives great

It’s more complex looking result than the actual technique. It sort of looks like 4 starts, 2 red, 2 white and becomes a maypole wrap. Less starts than this image, and tape being closer width to pole.

I always try KDE and after a while all the quirks and odd behaviors make me go back to GNOME. GNOME may not be easily themeable but it is predictable

Incidental Tangent to the surface where the stem starts.

https://www.commodoreos.net/CommodoreOS.aspx

The QR code and part numbers might lead you to an actual page of info on the part

It says Myrlyn to replace YaST GUI

Looks a lot like YaST

https://news.opensuse.org/2025/02/10/myrlyn-now-handles-community-repos/

But yeah, I liked all the easy config stuff in the Yast Modules