As you said. I tried this and it fixed everything. Thank you

They are flat

Thanks. Will try this.

When I switch to 0.2mm the time goes to 83 hours, so I assume there is still some error. What slicer do you use?

Here is what I remember.

Creality ender 5 s1 Creality slicer High detail profile (Infill % 15, speed 100, nozzle temp 205, bed temp 60, z axis 0.1) PLA These were the default with no changes.

I am not sure what other parameters can be changed.

I will post a screenshot tonight. I did notice that 99% of the time is on the outer wall, this is where I noticed the pauses when I simulate the print.

Layer height is 0.1mm. it’s odd, because it happens on specific curved areas. There are no pauses on other areas that were recently printed.

Shinobi and choplifter were my favorites.

Everyone feels this way. For me, positioning my thumb and holding the guitar neck closer to 45 degrees made this cord (and almost everything else) much easier. When you are struggling, it can also mean that your hand muscles are getting tired. Take a break and come back to build up strength.