Which is to say, not very far on this at all but I think I have a good idea on how have my cake and eat it too for desiccant for my spools.

I am finding I can’t get the humidity below about 50% in my AMS and the silica I am using needs constant refreshing.

Well it seems there is stuff called activated alumina that is pretty good and honestly about the same costs as silica beads, but I need to be able to put it in the oven to refresh it. Which doesn’t work well with my 3d printed desiccant holders.

Insert, cheap tea strainers.
It seems I can get ones that are 4cm in width by 6cm in height that are made out of stainless steel that I can actually put straight in the oven.

So, I am working on getting the parts and items but was wondering if anyone else has done this or have any suggestions before I start grabbing stuff?

  • Imgonnatrythis@sh.itjust.worksEnglish
    11·
    8 hours ago

    Why does your silica need constant refreshing? Has it always been that way? Perhaps you have a moist reel or two in there that need a good cook off in a filament dryer. I would look for more root cause for the humidity issue rather than hope another desicant will be a Gosend. Silica is pretty good stuff, I think you may end up dissapointed with this strategy.

    • Krauerking@lemy.lolOPEnglish
      21·
      7 hours ago

      Probably got a wet filament but they are all new and I have tried to give them a quick run through the dehydrator I have which is part of the goal of getting a better desiccant.

      Also it’s like 80% humidity where it prints so at 45% it’s not a small amount reduced.

      Also, silica is fine but there are other desiccants. Holding onto the past cause it’s good enough never explores if there is something better.

      • Imgonnatrythis@sh.itjust.worksEnglish
        12·
        4 hours ago

        Thought you were joking with the title but if you’re really a Trump type thinker go for it.

        Quick run through is no way to dry out a wet filament. Try all the new stuff you want and report back but doing things properly still works better.

        Fuck Trump

        • j4k3@lemmy.worldMEnglish
          2·
          3 hours ago

          Speaking as a Mod: What is the deal with the Trump comment? That seems uncalled for and random IMO but perhaps I do not understand. I have no issue with your opinion of Trump. I’m wondering why you are accusing someone else of being a “Trump like thinker” that is a pretty hot jab to wield randomly without context.

        • Krauerking@lemy.lolOPEnglish
          11·
          4 hours ago

          I was joking. I have barely started on this and thought it was funny. Why rush to insult for nothing?

          And I don’t care to share any of my findings with you if you downvote conversation and jump to insults.