I have been trying for many hours now to print this circular model, but have been running into inconsistent extrusion and stringing. just before printing this, I successfully printed a set of Hextraction tiles, so I’m not really sure what the issue is. I also printed this model successfully in the past with the same settings.

I am using a Sovol SV06 with stock firmware, and PLA with the hotend at 195° C.

I also did a full calibration to see if that would fix the issue, and it did not.

    • remoteloveEnglish
      2·
      2 months ago

      All good! It’s the same situation as I described and I see that increasing temps did help. It’s good to do a temperature tower test for quality and also a full speed test after that. After temperature calibration, print a square that is only 2 or 3 bottom layers that covers the entire bed at full speed or faster. (It’s essentially a combined adhesion/leveling/extrusion volume/z offset test, but you need to understand what you are looking at to see the issues separately.)

      If you have extrusion problems, the layer line will start strong from the corners, get thin during the acceleration and may thicken up again at the bottom of the deceleration curve. A tiny bit of line width variation is normal, but full line separation needs attention.

      Just be aware if you get caught in a loop of needing to keep bumping up temperatures as that starts to get into thermistor, heating element or even some mechanical issues/problems.