2001 Infiniti QX4

Placard on car says 26 psi cold

Tires say 32-49

Rear tire is set to 27 cold

Does this look under-inflated? What’s the lowest I should go?

  • Successful_Try543@feddit.org
    link
    fedilink
    English
    arrow-up
    13
    arrow-down
    1
    ·
    edit-2
    2 months ago

    If there is a minimum required pressure written onto the tire, I’d go with that one. A little more than the pressure required for the car doesn’t hurt.

      • Zwiebel@feddit.org
        link
        fedilink
        English
        arrow-up
        3
        arrow-down
        4
        ·
        2 months ago

        Why is everyone recommending the minimum here? I’ve always heard to go a smidge above the maximum for the fuel savings

        • Annoyed_🦀 🏅@monyet.cc
          link
          fedilink
          English
          arrow-up
          14
          ·
          2 months ago

          If by maximum you mean the pressure recommendation by the car manufacturer, then yeah it will help with fuel saving. If by maximum you mean the pressure provided by the tyre manufacturer, please don’t do that lol. Jumping from 26psi to 32psi isn’t much, but jumping from 26psi to 49psi is way too much especially for car with only 1 passenger, it’s gonna wear the middle of the tyre without the weight pressing down to give it an even wear. The money you save here will be used to replace the tyre earlier than it should. Will also cause terrible braking.

          • glarf@lemmy.world
            link
            fedilink
            English
            arrow-up
            3
            ·
            2 months ago

            Yep I have to second, you lose a ton of safety when overinflating tires like that due to the tire not gripping the road as it would if correctly inflated. Not a trade off I’d make with my life.

        • Hubi@feddit.org
          link
          fedilink
          English
          arrow-up
          4
          ·
          edit-2
          2 months ago

          Because on OPs car the recommended tire pressure is lower than the minimum recommended by the tire manufacturer. Increasing it even further may affect ride quality. In most scenarios your approach is correct.