I have an Ender 3 S1 that I use every couple of months at this point because it’s just such a pain to use. I have to adjust the bed tramming and z offset and run auto bed leveling for every single print and often times that’s still not good enough.
It will often take 30+ minutes just to get the first layer going down successfully.
Is this a me problem or did I lose the creality lottery?
Ender 3 pro owner here. I definitely need to level more than this person, but not even every print. I’ll go months printing nothing and when I fire it up, I get excellent adhesion right off the bat, no issues. Also never touched the z-offset, only fix it with manual leveling (no auto leveler)