Nintendo Switch emulator Yuzu will utterly fold and pay $2.4M to settle its lawsuit
www.theverge.com
Just about a week after getting sued.

This also includes ceasing development and destroying their copies of the code.

The GitHub repo page for Yuzu now returns a 404, as well. In addition, the repo for the Citra 3DS emulator was also taken down.

As of at least 23:30 UTC, Yuzu’s website and Citra’s website have been replaced with a statement about their discontinuation.

Other sources found by @[email protected]:

There is also an active Reddit thread about this: https://www.reddit.com/r/Games/comments/1b6gtb5/

    • sploosh@lemmy.worldEnglish
      2·
      10 months ago

      Your Switch needs to be hackable. If yours is any revision beyond the initial release chances are you are out of luck. I set it up a long while ago so I can’t recall the steps, but googling “Nintendo switch overclock” will get you what you’re looking for.

      The Switch is based on the Nvidia Shield, whose stock clocks are roughly double the Switch’s. This means you can OC it without exceeding the manufacturer’s specs, which is pretty neat. Bringing the memory clocks up really helps titles like ToTK.

      • discomaticEnglish
        1·
        10 months ago

        I have a hackable Switch but I’m afraid of bricking it or something. Is that a concern? I’m pretty technically inclined but no genius.

        • sploosh@lemmy.worldEnglish
          2·
          10 months ago

          It is dead simple, just make sure you get one of the little jobbies that you slide down the right joycon rail to short the pins that you need shorted - you’ll be doing it often when you’re setting things up and you don’t want to be messing around with a bit of wire. I seriously doubt that you will brick anything, especially if you take your time and read everything through before you get started. These instructions should get you where you want to be.