Hi all,
Purchased some empty full sized pans. Out of about 10, 4 of them have this wedge shaped cut.
It’s very deliberate. It’s not a manufacturing fault.
What do you think the purpose is? I can’t fully fill them, unless on an angle.
I’m a little stumped. Any feedback welcome.
Thank you
It feels like that. But 4 totally identical defects? I mean it could I guess, if there’s a repeatable issue.
If they’re injection molded, and there’s a problem with the flow or the pressure, it could produce several runs that have the same void in one pan before someone notices and fixes it.