cross-posted from: https://lemmy.world/post/766830

STM32C0 is a new line of Cortex M0+ Microcontrollers this year. Low-end STM32 chips have been trying to dethrone the 8-bit crowd by offering a 32-bit ARM Cortex M0+ for some time, and I welcome this competition. STM32C0 is cost-optimized with 8-pin to 48-pin form factors, and targeting very low end with 6kB SRAM and 48 MHz clock speed.

SPI, UART, I2C, 4+ MHz XTAL and 32kHz XTAL support, multiple timers for PWM, 12-bit ADC with best case 2.5 Megasamples / second.

Not bad for 61-cents (quantity 1k) at Digikey, ehh?

I think the 8-bitters still seem to have more I/O features, but this is a pretty competitive 32-bit chip on the low end. ST-micro is selling this chip as “entry-level 32-bit”, saying that you can keep code-compatibility as you scale up your projects. After all, ARM is ARM, be it a tiny Cortex M0+ or a higher end M33, M4 or M7 chip.

For people hoping to scale designs up and down, adding STM32C0 line chips is probably welcome to the STM32 hobbyists.

  • dragontamer@lemmy.worldOPEnglish
    1·
    1 year ago

    I actually do have a hot-air gun, a pancake-griddle, and a soldering iron + some lab experience from college a few years ago :-) (Heat from below + Hot-air heat from above leads to more consistency. A real life hot-plate is much more expensive than $20 pancake griddles though. You can’t get around the hot-air gun though for a lot of these parts)

    I’m not against soldering. Its the designing of the PCB board that trips me up.

    When its DIP-8, I can just buy proto-boards / breadboards and a few wires and everything hooks up quite well. I do have a few SOIC8 to DIP8 boards when I need to use an SOIC-8 or other SMT board though… but its an extra step that’s kinda annoying.

    My knowledge gap is KiCAD. So sticking with PDIP8 and anything that has a SMT->DIP conversion board is my preference.

    I guess your point is that there’s plenty of conversion boards for SOT-6 to DIP or whatever? Which is true, but… I really should just start taking advantage of Digikey Red + KiCAD and start making proper boards. Those converter boards are more expensive than a custom USA-made Digikey-Red 2-layer board in practice. Its just a knowledge gap of KiCAD that’s stopping me from doing this…