Did he have to flee by running through a lavender field? (:

They could just delete the file to deny you access to your db?

Mussten eine geplante Radtour wegen Krankheit absagen, deshalb unerwartet Urlaub in Balkonien. Auch nett. :)

Tja.

Irgendwann würde ich ja gerne mal wieder nach Berlin zurück, aber vielleicht doch auch eher nicht :(

Statt nach “Aktiv” nach “Neu” zu sortieren hilft bei mir, etwas mehr Abwechslung hereinzubringen.

Ideal fände ich aber auch eine “gleichberechtigte” Anzeige (je ein Post von jeder Community bis jede abonnierte ebensolche angezeigt wurde, dann wieder ein Post von der ersten etc.). Sonst gehen posts in kleinen Communities doch leicht verloren.

My condolences! Copying the data around may be reasonably straightforward if you can get it out of the snap (it’s just a directory, after all), but I have no idea how the database is setup for it. Good luck nevertheless!

I’d hope for the exact same performance with Docker (or KVM) as on a baremetal host, unless you’re doing userspace networking for ultra-low latency Nextcloud :D (and even that I suppose you could PCI-passthrough the network card?)

No worries :) Let me rephrase the question though - what installation method would you be using if you could?

So far I’m reasonably happy with a baremetal installation, but considering moving it into some kind of VM.

Not using Nextcloud in snap and not sure where I said I was using it inside snap? What installation method are you using at the moment?

I have nextcloud running just fine (with Apache) on a non-443 port. What issue are you seeing exactly? Once your webserver is listening on your port of choice, Nextcloud will show an “untrusted domain” warning if the domain/port have not been set in config.php properly. After that is done, it works perfectly for me.

Previous release had PHP 7.4, new one has 8.2. Nextcloud 24 supports 7.2 - 8.0, 25 supports 7.2 - 8.1 and 26 supports 8.0 - 8.2, which is a bit inconvenient.

To upgrade, I first¹ upgraded Nextcloud to 25, then PHP to 8.2, removed the versioncheck in Nextcloud to accept PHP 8.2 and then upgraded to Nextcloud 26.

Otherwise very smooth - even the usrmerge was absolutely event-free.

¹) of course what I actually did first was upgrade Debian/PHP without checking beforehand and then installing PHP 7.4 from the previous release again.