The way the test is implemented through orca slicer is actually a bit confusing. The forks of bambulab and orca slicer are likely intermingled. I used the default settings given in the drop menu then it imported a model. I then started the test as is without modifying anything.
I honestly have no idea which the correct values were for the p1p. Now that you mentioned it, I suppose I should have checked with bambulabs online manual. I hadn’t thought about that.
I’m currently trying to solve some seam artifacts. I assumed retraction has something to do with it.
The print is so small and I literally cannot see the results. I can’t even photograph it clear enough with my camera phone.
I must have done something wrong because the whole tower looks pretty much the same except for a clear overextrusion around the middle on one side. The rest have really thin barely visible strings that don’t go very far.
Gotcha, thanks.
Yeah just the residue, no visible pieces of tape. Sorry for the late response.
Glad to know. I wasn’t aware of dead zones unil now. I’ll have to research that.
I admit I tried using every gram. Still I found some of the tape residue on the inside of the spool. Thanks for the advice.
I guess it would be small. What about a small triangle of it?
I’m asking because I got a weird droplet in my feed that showed up in a duplicate print.
Yeah I haven’t heard of it. Thanks for the info. Not sure if that would solve my problem though.
There’s so many advantages to making your own. No wait time, and custom pieces. Only the connections are needed.
I had assumed they were referring to pouring and not a resin printer. Using a mold is definitely a full proof approach.
You might be right about that. Still being able to print at that quality or near it, would look good.
Yeah I hadn’t thought about getting the smaller bits off the plate.
Team Perfect here we go.