Just note that if you 3D print something, if you use the wrong material, there’s a chance it may melt.

That’s pretty cool - seems like a fairly involved project! How long did it all take you?

That’s actually a surprisingly powerful SBC for what it costs. Does Pine64 stuff come with fancy looking enclosures like that one, too?

What a load of crap. I knew Netflix was expensive, but ten bucks a month per person with ads? That’s unreal! Even bundling only gets that down to ~$7, which is still BS.

I would heavily suggest not doing this. HDDs are significantly more reliable than flash storage when it comes to long-term, power-off data retention. Period. There’s a relatively little-known fact about SSDs and flash storage where they aren’t actually rated to sit around with data on them for all that long. The voltages stored inside of them degrade and the data is slowly lost over time if they aren’t powered on. The enterprise SSDs that I work on are rated for 3 months - as in, set it on a shelf for three months, and after that, if you don’t power it on, it isn’t guaranteed that all of your data will still be there. And this is talking about ultra-redundant, enterprise SAS SSDs. MicroSDs don’t have any of that redundancy. (And yes - this implies that setting a bunch of important flash drives in a safe for ten years is not a great idea. That is true! It’s unlikely that you will experience data loss, but it’s more likely than with an HDD)

Just back them up in multiple places. I’d suggest Backblaze for offsite storage; I use it to back up my important data.

A plain old samba share works just fine, I’ve got a few running at home.

~$2500USD/ea, for anyone else as curious as me

Out of curiosity, what’s wrong with medium? (Serious question)

@[email protected] - are these available somewhere as full res pictures already? And/or will they be after the desktop is chosen? Or will only the chosen one be available?

Yep. Broadcom fucking sucks, they’re and they’re really good at doing this. Can’t wait until VMWare costs more than the systems it’ll be running on 🙄

Must be part of Reddit’s new rebrand

Although if y’all sold a stuffed animal of whatever adorable thing is in the middle right picture, I’d buy it in a heartbeat

Top left gives me amazing vibes

Awww I knew there was a catch! Of course you’re overseas ;-; sad American noises

Redwoods are so freakin’ cool.

That is all!

The Crucial option is good because of more upgrade ability in the future. But - here’s another idea, that’s right around $100 but will be even smaller & more portable: Drive like this one: https://a.co/d/2dnQ1w1 With an adapter like this one: https://a.co/d/eiYVTvu

That said, I think your crucial SSD+enclosure would work just fine. I’ve got one of the m.2 adapters above and it’s a handy little thing so I know that works, too.

We need more info about the drive. Is it new? If so, absolutely RMA it. Just isn’t worth the headache even if the self test reports fine. If not new, how many hours? Reads? Writes? Any failures reported by SMART? Et cetera.

The more info, the better. I work in SSD failure analysis/firmware development.

Fred joins the game and teleports to square 3,3. He has a red aura around him. Nobody’s quite sure what it does, but it probably isn’t good.

The pins are called “DuPont connectors” - you’d want to chop the LED-side and use a 3 pin female DuPont instead of a 2 pin. If this is something you think you’ll do more than once, I’d buy a crimper on Amazon or wherever (they’re ~$25 last time I checked). But, you could also pull the two wires out of the connector and keep the crimps on them, and then just stick them into the DuPont plastic shell which would avoid needing a new pair of crimpers. To remove them, there’s usually a little tiny plastic tab on one side for each contact that you can pry up with a little tiny screwdriver.