According to a post on the 3dprinting subreddit that was recommending different budget options, they were not recommending the Ender 3 anymore because QA would have in fact went down like you said. (Their name is made, they can cut cost to increase profits now…)

They were only recommending it if you went for the Ender 3 S1 since it had more features than the base Ender 3 / Pro / V2.

I have an older Ender 3 Pro that I modded quite a bit over the years and would also agree this is more a machine if you want to tinker with it. One important thing to note is that almost no upgrades will result in higher print quality when compared to a well tuned base Ender 3. The mods simply made it a bit more reliable IMO or reduce how often I need to calibration it.

I also agree that if you don’t want to tinker with it, get something else. It will be more expensive upfront but if you take a cheaper printer that you mod over time, the cost will end up being similar. But it’s a decision hard to make if you are not sure you will like the hobby, and an Ender 3 or other similar budget printer can still be OK without modding if you don’t mind the limitations.

And if I were to buy a new printer today, I’d definitely go for something better with more features built in that I wouldn’t have to mod to achieve the same functionality.