Curious if I can get a sanity check off my problem diagnosis (or alternate theories!)

I tried a long print today and wound up with a 1/2 inch layer shift on the x-axis near the end of a long print, taller than most I’ve done, not certainly not the tallest.

It occured on a spool I just opened a few days ago and printed two other ~250g pieces with. I’m very certain that I never lost control of the filament end. My spool in mounted using the stock ender 3 mount on the left side is the gantry and a filament guide arm.

After reading a bit, I’m thinking this was due to the filament on the spool loosening up from a large travel and then binding on itself. Seems the easiest way to fix this might just be to put more space between the spool and the printer so the slack can absorb the shifting without pushing back on the spool and loosening several turns off filament.

I don’t think it’s heat or any general axis binding as the shift only happened at a single layer, at a hight that I’ve been able to print through before, and the motion generally appears smooth when I exercise it.

So… Experimentation will probably prove me right or wrong, but before I sink another day of print time… Does that sound reasonable or am I missing a common problem?

Edit: Solved, see comment by @[email protected] for the actual problem. Many thanks to all who provided their thoughts!

  • bemenaker@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I was having an issue like this last week, and surprisingly, I was able to finish my print by using a new slicer. I was all prepared to go buy a new board for my ender3v2. I had even put a bigger fan on the board to try more cooling but still kept getting it on this large print. I sliced it in superslicer instead of cura, and it printed. Unless you’re just eager to spend money and replace parts, not necessarily a bad thing, I would take a stab at a different slicer first.