As this community is just starting, I thought learning more about each other’s setups would be interesting.

I’ll go first:

  • DS916
  • 4x8TB Hard Drives: 3 WD Reds, 1 Seagate Ironwolf (oldest drive is 53,150 hours or just over 6 years)

I haven’t had to replace anything yet (knock on wood)!

  • Brock@lemmy.world
    1·
    1 year ago

    Might get shit on here. What’s the most cost effective synology I can use for a plex server that can run maybe 2 plex streams at 1080 or one 4k?

    • gadgetzombie@feddit.nl
      1·
      1 year ago

      Any nas will do for storage (if you can get a + model though for BTRFS) and then for Plex get an Intel NUC or Dell Micro with any Intel chip with UHD graphics 730 with I believe is anything after 10th gen

    • bratling@sh.itjust.works
      1·
      1 year ago

      Man, almost anything now. Transcoding isn’t really needed very often since streaming sticks (Roku, AppleTV, Fire, etc) now reliably have hardware video decoders. So, almost all the NAS has to do is shove the file over the network. Almost the only way you’d need transcoding is if you wanted to stream video out of your home network to remote devices.

      So, if my guess that you won’t need transcoding is correct, then just buy the cheapest NAS that has a couple drive bays.

      (There is such a thing as too slow. I have a 2014-vintage Synology DS214se, which was the low end model even then, and Plex clients take up to a minute to load all movie posters, and it can take a minute for a video stream to start. But if you are buying something made in the past few years this won’t really be an issue.)

      The Synology DS220j would probably be my pick for that. Or maybe the 120j if you don’t care about data redundancy.