My project is a “breathing” white 12v LED strip controlled by an esp32 on a dev board, and switched with an IFLZ44N mosfet.
In my video you can see it working but also hear the power supply complaining.
I’m using the LEDC Arduino library which allows me to select the frequency and resolution for PWM.
If I set the frequency too low the whine is extreme, but at this setting it’s the best I’ve been able to achieve, which is about 9000Hz. Unfortunately you can still hear the sound from across the room!
It is a cheapo solid state power supply that claims it can output 12v up to 25A. I tried my desktop supply and it emits some whine too, so I don’t think replacing the power will totally fix this.
Is there a technique for tuning the frequency or even just masking it somehow?
470uf should be fine - bigger is almost always better, except if you sacrifice higher ESR for it in an application that requires lower ESR. It’s pretty common to combine a large cap with higher ESR (like an Electrolytic or tantalum) with low ESR ceramic caps. That way the large cap can handle the high speed bulk C while the smaller cap can handle the high speed stuff and switching edges.
Did you make sure the cap you picked out was rated for the voltage you are working with? For hobbyist stuff it’s usually a good idea to heavily derate voltages, to avoid blowing things up. For example, if I was working with a 24V power supply, I wouldn’t nab a 25V cap; I would spring for a 35V (or even a 50V if I’m feeling particularly paranoid). You’ll see derating like this commonly in commercial applications, and extremely frequently in military/aerospace applications.
As a rule of thumb you should always derate by at least 20%, then increase to 100% depending on how much ripple or switching the cap will see. For this application I’d probably want to derate to at least 50%