Using a vinyl cutter and mini-sand blaster I made some alternate universe corporate schwag! I like the idea that someone might have swiped these during an interview before both companies had their ‘accidents.’

  • shalafi@lemmy.world
    link
    fedilink
    English
    arrow-up
    7
    ·
    3 months ago

    Excellent! I use glass etching compound for the same effect, but getting it sharp is a hella process. That looks far better.

    Looking at sand blasting kits and they’re way cheaper than I thought. What’s your rig and process?

    • Nik282000OP
      link
      fedilink
      arrow-up
      5
      ·
      3 months ago

      Oops, replied to the wrong comment, in actual answer to your question:

      I’m using a Cricut vinyl cutter but would never recommend one to anyone, their locked down cloud app is terrible. After I get a stencil cut I stick it down and then mask off the entire rest of the glass with tape. For a blaster I am using a tiny one that looks like an airbrush, it was ~$100CAD on Amazon. I use a pair of old socks as gloves in the side of a big clear plastic tub they keep the grit inside and let the air out! And that’s about it, I just blast all the exposed glass until it is frosted, I don’t think you can ever blow right through but if I hit one spot for too long there is a step in the glass at the edge of the pattern.