Built out my ploopy mouse today, it’s been sitting on my shelf for a while. I got the self-assembly kit, had to solder on one through hole component.
So far I’m enjoying the mouse, the right mouse button is a little sticky, but I’m sure with a little readjustment it’ll fall into place.
Every part of this mouse is open source, the hardware files, the PCB, the schematic, the firmware which is QMK. There’s a lot to love here.
I’ve been playing some video games, and so far I enjoy the mouse quite a bit.
If I do have one complaint it would be the central scroll wheel doesn’t have a detent, but that might just take some getting used to
I would love to see a kinesis style pinch mouse like the DXT2.
@[email protected] @[email protected] Great device, thank you for making it open source.
Note: I ordered their USB cables, just for solidarity, and assuming they found a cable that was very effective for a mouse, the cables I received were very strong, too stiff really to be used for a mouse cable. Luckily I had some very flexible braided USB cables already. So if you’re going to order from them do not order the USB cable
I did not print it myself no, The printed parts came with the kit. But I am free to print them again if I want to
I looked at doing it all myself, I priced out the PCB at PCB way, for run of five(minimum order size) it cost me $125. The mouse itself with all the bits and pieces is $100. So I just went with the kit
Yeah the ratcheting feeling when you move a mouse wheel on some mice is nice. But I’m getting used to this infinite wheel paradigm
https://github.com/ploopyco/mouse/wiki/Ploopy-Mouse-Kit-Assembly
This is what I did today basically. I followed these assembly instructions.