I just built cheapino 3x5_3 split and of course need to get miryoku on it - there’s a qmk branch here https://github.com/tompi/qmk_firmware/tree/cheapino but could not find the board over at miryoku.
It also has a special encoder, wondering how one could use it in the most meaningful way with miryoku…
Could someone describe the steps or create a miryoku config?
Not sure what went wrong, but did you try the same uf2 file i did? Seems like official miryoku to me…
Yeah the same and default alphas means Colemak Mod dh normally - I assume it’s my fault and the key mapper… Checking in a few hours and will report.
let me confirm it was an issue with karabiner-elements… I totally forget, thx for the great comments @[email protected] and @[email protected] I now just realize that the Miryoku Colemak DHK is also not the default, but I’ll just swithc that back to default and it will most likely work!
thx all!