I just dropped this on Printables: A FreeCAD based custom size box generator. I’ve been using it for all kinds of stuff. Maybe some of you lot will get some use out of it, too.

https://www.printables.com/model/770701-parametric-simple-custom-box-maker-freecad-generat

Plug in your parameters, make a box with filament hinges – No hardware required. No screws, no nuts, no supports, no glue, no Fusion, no proprietary software, no going cross-eyed looking at OpenSCAD code.

(And yes, the default size in the file will make an M:tG card deck case.)

  • Carunga@feddit.deEnglish
    3·
    4 months ago

    Cool. Hope to print one later. Last week I have been searching for exactly this and could not find it. Did you think about an option for adding some simple dividers inside the box?

    • dual_sport_dork@lemmy.worldOPEnglish
      3·
      4 months ago

      I’m sure there will inevitably be innumerable variants. I was thinking of adding a generator for Gridfinity inserts, and dividers wouldn’t be too tough to add, either. Or handles, or swivel latches, etc., etc.