Got my rg35xx-h and the provided screen protector had no glue, so I ordered one off Amazon, this is what came. I think I’ll just stick to my 3d printed case.
EDIT: Edit just checked these didn’t have glue either, what’s going on haha Brand is Mr Sheild
Looks like it’s running an amlogic chip. The only experience I have with linux and amlogic is the radxa zero. I’ve got a few with armbian and one with openelec. They are solid. I wonder if this gets a mainline kernel or not? I like the design.
I’ll try and remember to dig about when I setup the SSH and let you know
Not by a long shot, it’s on 4.9.170 about 2019 that’s a bit worrying :D
Is it perhaps static cling, or do you have to apply with a water/soap solution?
Thought the same even though it’s not in the instructions used a bit of isopropyl nothing
I usually just cut these down to the correct size I want with a ruler and a utility knife.
