I am stuck with very sticky wifi clients. So I do find “mesh” with 802.11 v/k/r and a network controller does help devices roam although all roaming is supposed to be initiated client side.
What is your internet package speed supposed to be?
Could be a damaged cat cable.
Its also possibe the ends have been terminated differently.
Doing an A termination on one end and a B termination on the other end will lead to this behavior.
Is the easy band switch on the asus set to full band?
I woud assume its mps otherwise.
Could be the other way for the frequency switch if the screenbeems default to dosis compatible.
With wired backhaul there are less options. What are you currently using as your wifi access point?
It really depends on what your client devices are/ how many clients you have.
Not many clients support 4x4 mimo or 160 mhz channels widths (the main difference between the xt4’s and the ax86u) I also can not confirm if those fesrures would work with ai mesh. To get better signal outside i would add another access point there rather than teybto upgrade inside.
Paying for a mesh system with a extra backhaul band that can only be used for backhaul like the pre wifi 6e orbis is a waste of money. As for what hardware to recommend it depends on your plan speeds, devices you are connecting and if you need a faster lan connection.
I am useing deco x20’s in wired backhaul and (dual band access points) performance is peitty good (maxes out my 300mbps plan) and they are easy to setup. They are missing features like vap and vlan tagging compared to a more prosumer setup.
I have x20’s seems that the 2.4 ghz band is cutback on the x10’s my x20’s are hard wired so I can’t say how they work as a mesh.
As you are using wireless backhaul I feel like the ax 3000 devices would be most useful but you also only have a plan speend of 50mbps. So evey oprion should saturate it if placed properly.