It is but it’s perfectly on time for second breakfast.

By then you’ll be fluent in German.

So does it mean I’ll never see that meme again while using the steamdeck?

Dishonored runs quite well. I’m also playing God Hand with a PS2 emulator. What a ridiculous game.

What setup did you use? I’m interested in doing this as well. I’ve already self hosted a NAS with vpn access using an RPI4 with PiVPN. It works quite well.

Yes inquisitor, this post right here!

deleted by creator

Overhangs are always difficult in 3D printing and your part cooling fan makes a huge difference in this. Also your print speed and temperature are factors.

This model however can also be printed sideways, you’ll have lower bed adhesion but it won’t have any overhangs this way.

It takes that long to fully recover. Holy shit.

Looks like it is a crysis already.

Hell yes it was.

Me ordering a vegetarian meal in the airplane.

Woman yelling at cat.jpg

It’s made of wood.

Applies to the Dutch as well.

I hope aliexpress is better. I buy a lot of stuff from there like electronics components which aren’t really sold locally anymore. Also tools and arduino related things…

Ackschually, you don’t need to print them entirely sideways for structural integrity. Printing at an angle should also work and you don’t get so many artifacts from support material.

Can confirm. So far I’ve gotten an external monitor, keyboard, mouse, docking station and a stand for it so it can be used as a laptop as well while traveling.

It certainly has issues but it’s an impressive device.

I’m not particularly knowledgeable about IT but I avoid IoT like the plague. Everything should run locally and if I want to control it from away I’ll use a VPN to home.

Nice to hear! At the moment the spindle, if it has the right to be called that, is a 775 motor with a chuck attached to it. Which is good enough for circuit boards and wood. Perhaps aluminium is doable as well as long as the feed rate is kept slow enough.

Should milling steel ever be on the table I’ll make a larger machine and will use leadscrews on X and Y instead of belts and perhaps dual Z motors.

I’ve also designed the build around materials that were readily available such as the 18mm X rails. Apparently they’re quite obscure since they aren’t sold on typical Chinese webshops.

Thanks! Indeed the Z axis rests on only one MGN9H block. For stability it can be changed to two sliders per rail. For circuit boards and wood it should be strong enough to handle the load.

As for github/launchpad, I never used those before for sharing anything. I will look into those.