I was testing the new tree support function in cura. The results was quite good afterall.

STL file

  • Mechanismatic@lemmy.ml
    link
    fedilink
    arrow-up
    3
    ·
    1 year ago

    Next time you should try using the Ph’nglui mglw’nafh Cthulhu R’lyeh wgah’nagl fhtagn setting.

    • CosZnOP
      link
      fedilink
      arrow-up
      3
      ·
      edit-2
      1 year ago

      I tried that, it didn’t work out. It took me weeks to remove all the tentacles from the printer. 🤨

      • Mechanismatic@lemmy.ml
        link
        fedilink
        arrow-up
        3
        ·
        1 year ago

        It’s also annoying having to wipe all the blood from your eyes and make sure it doesn’t drip on the bed because that messes with adhesion.

        • CosZnOP
          link
          fedilink
          arrow-up
          3
          ·
          edit-2
          1 year ago

          Let’s not talk about that. It was almost better the Nyarlatothep slicer, you would end up forgetting most of what have happened duting the print time but the print was perfect… ok tainted in blood and sometimes made of human flesh, but hey! No lay line at all.

    • CosZnOP
      link
      fedilink
      arrow-up
      1
      ·
      edit-2
      1 year ago

      I already did that. I used car primer and wet sandpaper to clean the print line.

      I’m trying to make a set with what I found online