So this was the product of a mistake. I had already taken my previous project (https://lemmy.blahaj.zone/post/24039237), measured it and replicated it in LibreCAD for a reproducible pattern and this was my attempt to use that pattern. Problem is that the full length of the strap is longer than a piece of A4 paper so the pattern was split over two pages. Plan was to scratch each half onto my leather and cut it out in one go.

However I got a bit too enthusiastic and accidentally traced and cut the entire thicker section of it out… So rather than abandon it I made the best of the situation and found a contrasting but similar thickness leather and tried my first join! A bit of glue, some accurate stitching chisel placement and they were attached! I was genuinely shocked as to how well it worked, I thought much more material would be needed for that to work that easily, or that I would end up with it looking a mess seeing as the strap holds a lot of tension in it when worn. I’m aware this isn’t necessarily the right way of doing the join, I was in a bit of a hurry and just kind of skimmed the instructions (and not very well), I want to try a better, stronger and more decorative stitch next time.

Either way, this is my second iteration of the same design, its fascinating how just changing the material and colour a little changes the vibe of the entire thing. I’m going to keep iterating on the same design, get some snaps in rather than the SB closure, skive down the edges of those retaining bands to reduce the profile of the edge, get some edge bevelling or edge paint involved, try to do some lining etc.