So glad I saw this before finally getting around to buying one. This is annoying but I am not surprised with the enshitification of everything nice going on in the world.
For a semi open source alternative, Qidi Plus 4 has great hardware. However their QC is not nearly Bambu tier so having to replace a part is possible.
Another good write up on the subject https://www.reddit.com/r/BambuLab/comments/1i3gq1t/why_you_should_care_about_bambu_labs_removing/
Don’t update your printer’s firmware: Bambu will likely be tracking download and installation counts. Make it clear you won’t run this firmware.
Contact Bambu Lab: Politely express your concerns using their support portal. Make it clear that you value open access and will not accept this change.
Vote with Your Wallet: Pause any purchases of Bambu Lab products or consumables and consider alternatives. If the change goes through, weigh selling your printer or avoiding updates.
Withdraw Your Support on MakerWorld: If you’re a creator, remove or relocate your models to other platforms and consider cashing out exclusive points.
Spread the Word: Share this issue widely to ensure others are informed and can join the pushback.
Wasn’t it that even their spools are vendor lock-in since the beginning?
I like how fast and seemingly reliable those printers work, but I never considered buying one.
You can use non bamboo spools with their printers, idk about using bamboo filament in other printers though
