I’m just getting into 3d printing and I’m looking for some recommendations. My budget is $400 and I’ve narrowed it down to the sv06+ or the Ender-3 V3. I like that the print size is bigger on the sv06+ but all reviews point to the Ender, do you guys have any recommendations for me?

Also maybe the bambu a1? Or a1 mini? I don’t like that the firmware isn’t open source though.

I’m OK tinkering but just want some insight.

Thanks!

  • reddwarf@feddit.nlEnglish
    101·
    22 hours ago

    I’ve been eying 3d printers for years before I finally bought one. My main argument for not buying one was always the same: I am not prepared to start tinkering with a utility device. It needs to be on a similar level of a laser printer. I send a job to print to that device and it prints, that’s it. Not a 100% comparison of course but it does tell you what my mind set was.

    Cue 1 year ago when I noticed the Bambu P1S. Looked at the specs, saw some youtube videos and decided that this might be the time, it is possibly close enough to being a simple usable device.
    I bought one and boy, did that device deliver. Load the right filament you want to use, send job to printer and it just prints. The quality is (for me at least) quite bizarre. Some parts I have printed look like it was formed by molding, it is that good.

    Nothing but praise and a firm recommendation from me on a Bambu printer.

    Note: I have no experience with any other brand (as I avoided all because of stated reasons and not wanting to tinker) and I currently have zero interest in any other brand due to being so happy with my P1S