I’ve printed similar objects with a different colored PLA, but I ran out of it and switched to this.

Is it possible that this could be influencing the outcome?

I have tried reducing the printing speed by 50%, but this did not seem to have a significant impact.

[SOLUTION] The problem was a loose screw. The offending part as well as the new result are pictured below. It’s not perfect, which I guess is actually a part of the model this time, but it’s good enough for my purposes and way better than what it was before.

I figured this out by twisting the Z-axis thingy manually all the way to the top to see if I could feel any issues. Towards the top, it would start to ‘skip’, where I would turn and pretty much nothing would happen. I assume this has to do with the lack of lube at the top because my prints rarely go that high. I checked to see if the screws were loose, and sure enough, the top one was. I tightened it up and now my printer is printing like the beast I remember!

  • john89OP
    4·
    6 months ago

    Thank you for this information. I am using a Creality Ender 3 V2.

    • Chuymatt@beehaw.org
      3·
      6 months ago

      So, this seems counterintuitive, but slightly loosening the part that attaches to the x axis can help as well.

      For clarity, you loosen the brass fitting on the x axis that attaches the rod to the x axis.