Also I made a new acc so I can use Voyager! Previously used @[email protected].

My main reason for moving to Lemmy/Kbin was to have 3rd party app support, and Beehaw ceasing Lemmy updates has now prevented that (for Voyager, at least). I still love Beehaw though, but the website is really bad on mobile.

Anyways I’ll comment a picture when this print finishes 🙏

  • SmoochyPitOP
    20·
    2 months ago

    It’s finished!

    The creator of the model replied below with links! I highly recommend this model if you need a stylus, it’s working great!

    I should’ve been a bit more careful with where I put support material— one side of the bridge part is a bit bumpy. But it still works, so I can’t complain too much. Also, the bottom part where it connected to the raft is a bit rough. Might be worth lightly sanding it down so it’s a nicer finish when stashed.

    • the16bitgamer@lemmy.worldEnglish
      10·
      2 months ago

      Happy you enjoyed my design, though I think you should’ve shared the printable/thingiverse link.

      https://www.printables.com/model/158481-new-nintendo-3ds-stylus

      https://www.thingiverse.com/thing:4895677

      On that note if it breaks (since you printed it upright, try printing it on its side with the nub facing up. You’ll need a raft and supports but it can be easily remove and the stylus won’t break… it’ll just bend.

      • SmoochyPitOP
        3·
        2 months ago

        Thank you for the design! It’s working great so far, but if it breaks I’ll give that a shot.

        Also I agree, I should have linked it. Sorry about that. I posted it to 196 because it was the most recent picture in my camera roll, but it really would’ve made sense to link it in the follow up pictures. I’ll edit that comment to point to yours, just in case.