Any ideas as to what I’m doing wrong?

This sphere has a ridge on it, and I’ve had miniatures come out with the base to be slightly offset giving a bit of a ridge.

I’m using a Halot One, lychee Slicer, and Anycubic Water Wash resin.

  • GrindingGearsEnglish
    2·
    7 months ago

    If it’s in the same spot every time, it’s very likely something wrong with the model. It’s inexplicable when this happens, but it does sometimes. Could try a different sd card, doubt that will make a difference, but you never know.

    To me, it looks too uniform and consistent to be something with the printer.