Anyone have any solutions for this issue? You’d think it would just bridge over the entire hole, don’t know why it’s doing this. We’re at 195mm height here and I’d rather not run a support the entire height of the model just for this little nub.

Using version 2.6.1

Edit: Model in question https://www.thingiverse.com/thing:5551428. Not my own, but getting some fun things printed for the Spooky season

  • remotelove
    link
    fedilink
    English
    arrow-up
    8
    ·
    1 year ago

    Just insert a modifier in there like a cube or something. Anything that gives it a flat layer to print would work, I suppose.

    However, I really need to see the layers below and above that picture to see what is actually going on.

    • MrQuallzin@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      4
      ·
      1 year ago

      That’s what I ended up doing, thanks! Put in a 0.2mm disk right at the problem area, now I’ve got a nice clean bridge.