I have cut my teeth on the Ender 3 Pro v2 printer by Creality. Neat little printer; it works wonders when/if it’s perfectly dialed in. The thing is, I don’t have the interest to dial it in like it needs to be. I just want to turn it on, send it a print, and walk away. I do t want to spend all morning (like this morning) trying to “auto-level” 🙄 the bed, just to not have it be level.

When I try to manually level the bed it’s worse: I can measure one corner 5 times in a row, and get 5 wildly different heights each time. And I’m even using the Creality BL Touch sensor!

I have upgraded the springs, and I’m using the wide knob’s, and spent days trying to tune in my printer. I’m also using the Jyers Marlin firmware (15x15).

It’s exhausting and not fun. Help me Make Printing Fun Again. 😩

  • PerogiBoi
    2·
    3 days ago

    Bambu P1S.

    I’ve never had a print failure. It’s so plug n play n walk away that I have it on a smart plug and turn it on from my phone, slice the print, and then send it without even going down to my basement where my printer lives.

    I only go down to grab my print and remove the test strip it prints right before starting the model. Love that machine.